76
Beyond the Basics
6. When the scanner has successfully received all data, End
appears. If the scanner received an error while receiving
data, End, d-Err, and its frame number appear. If the
scanner received a communication error while receiving
data, C-Err indicates the packet number where the error
occurred. If the scanner received a checksum error while
receiving data, S-Err indicates the packet number where
the error occurred. If the scanner received a length fi eld
error while receiving data, L-Err indicates the packet
number where the error occurred.
cloning your scanner
You can clone all the frequencies, trunking talk groups, and
fl eet maps programmed in your PRO-2051 to another
PRO-2051 using an optional interface cable and software
(available at your local RadioShack or www.radioshack.com).
1. Make sure the scanners are turned off and then plug the
cable into each scanner’s PC/IF jack.
2. While you press and hold E on both scanners, turn on
both scanners.
3. Determine the scanner which has the frequency data that
you want to transfer. This one must be set up as the “First
Unit”, and the other must be set as the “Clone Unit”.
4. On the scanner that is the “Clone Unit”, press
e
or
d
to
select CLONE, then press HOLD/RESUME.
5. On the scanner that is the “First Unit”, press
e
or
d
to
select FirSt, then press HOLD/RESUME. The data transfer
begins from the First Unit to the Clone Unit.
During data transfer, SNDFirSt appears when a scanner is
sending data and REC CLONE appears when a scanner is
receiving data. When the data transfer is complete, donE
appears. If the data transfer is not successful, Error appears.
