49
RESETTING THE SCANNER
You might need to reset the scanner if any of the following occur:
• The scanner’s display locks up.
• The scanner does not work properly after you connect power.
• The scanner is dropped or subjected to a physical or electrical shock.
Caution: This procedure clears all the information you have programmed into the
scanner. Use this procedure only when you are sure your scanner is not working
properly.
1. Turn off the scanner.
2. While you press and hold down
2
and
9
, turn on the scanner.
Note: It takes about 10 seconds until the reset is completed.
CLEAr
appears dur-
ing resetting.
Caution: Do not turn off the scanner while you reset it.
20-430.fm Page 49 Wednesday, August 4, 1999 1:29 PM