20
Limit Search
A limit search lets you search for active frequencies between upper and
lower limits that you set.
-L-
appears on the display during a limit
search.
1. Press
PROGRAM
, then
LIMIT
. Lo
appears on the display.
2. Enter the lower limit of the frequency range you want to search.
3. Press
WX/E
, then
LIMIT
. Hi
appears on the display.
Note: If the frequency you entered is not a valid frequency,
Error
appears. To enter a different frequency, start again from
Step 2.
4. Enter the upper limit of the frequency range.
5. Press
WX/E
, then
LIMIT.
Lo
and the lower limit frequency appear
on the display.
6. Press
t
to search from the upper to the lower limit, or
s
to search
from the lower to the upper limit. The current monitor memory
number starts flashing at the top of the display.
7. When the scanner stops on a transmission you want to save,
press
MONITOR
to store the frequency in the current monitor mem-
ory. The monitor number then stops flashing.
8. Press either
t
or
s
to continue the search. If you saved a frequency
in a monitor memory, then the monitor memory number on the dis-
play advances by one and starts flashing again. (If the last monitor
memory was 6, the scanner returns to monitor memory 1.)
9. To hold the frequency, press
LIMIT
.
-H-
appears on the display.
To exit the hold mode and resume the limit search, press
LIMIT
again.
Notes:
• You can press
t
or
s
during the hold mode to step through the
frequencies toward the upper or lower limits.
• If you tune to a search skip frequency, the display shows
L/O
(see “Search Skip Memory”).
20-509.fm Page 20 Wednesday, August 4, 1999 1:58 PM
