Using Key Tone and Vibrate
You can set the radio so it sounds a tone when you press any key except
PTT
or
FUNC
key. And
you can set the radio vibrate to alert received a signal when the radio is idle for 30 seconds.
To turn on the key tone and vibrate feature, press
MENU
key to activate the Menu function and
press
UP
or
DOWN
key until
icons and
ON
appears. Press
PTT
key to store the setting.
To turn off the key tone and vibrate feature, press
MENU
key to activate the Menu function and
press
UP
or
DOWN
key until
icons and
OFF
appears. Press
PTT
key to store the setting.
To turn on the key tone and turn off the vibrate feature, press
MENU
key to activate the Menu
function and press Up or Down key until
icons and
ON
appears. Press
PTT
key to store the
setting.
To turn off the key tone and turn on vibrate feature, press
MENU
key to activate the Menu
function and press Up or Down key until
icons and
ON
appears. Press
PTT
key to store the
setting.
When no keypress found in Menu mode, the radio will exit without save after 20 seconds
.
Using VOX
Vox operation allows you to transmit voice message without pressing any key. To activate VOX,
continually press
MENU
key until
VOX
appears. Press
UP
or
DOWN
key
to select the desired
level (There are four levels of sensibility 1 ~ 4, i.e. Lo ~ Hi ), select
OFF
to turn off this function.
Press
PTT
key to store the setting. When no keypress found in Menu mode, the radio will exit
without save after 20 seconds.
Note:
•
You still can send a page to the other FRS radio in VOX mode when the keys are
locked.
Using APO
You can set the radio to automatically power off when the radio is idle (no any key pressed or Tx
or Rx) for 30, 60 or 90 minutes. To turn this feature ON/OFF, continually press
MENU
key until
APO
and
30
,
60
,
90
or
OFF
appears, press
UP
or
DOWN
key to select the desired one, if you
select
OFF
, the radio will not automatically power off. Before the radio shuts off, the radio will
alert beep sounds. After auto power off, the radio can be wake up by any key press when rotary
switch in ON state.
Using Hi/Lo transmitter power
You can set the radio transmit power is 0.5W or 2W. The transmit power of channel 8-14 is fixed
at 0.5W only (FRS channel). To select 2W transmit power, make sure that the channel isn’t 8-14
and then press
MENU
key until
Lo
icon appears, if you select
OFF
, the radio transmit power is
2W, select
ON
to set the transmit power is 0.5W. When no keypress found in Menu mode, the
radio will exit without save after 20 seconds.
Note:
•
No Hi/Lo transmit power selection when Channel number is 8-14 (FRS Channel).
