E-15
648U-E-017A
Basic Operations
This part of the manual provides you with the basic
information you need to use your keyboard.
To switch power on and off
1.
Set the POWER/MODE selector to NORMAL.
2.
Press the keyboard keys.
3.
Use the MAIN VOL slider to set the volume to a
relatively low level.
4.
To switch power off, set the POWER/MODE
selector to OFF position.
To change tones
1.
Look at the tone list
*
printed on the keyboard’s
console and find the one you want.
*
See “GM Tone Map List” on page A-1 for details.
2.
Press the TONE button.
3.
Use the number buttons to input the 2-digit
number that identifies the tone you want to
select.
Example:
To select “26 ACOUSTIC BASS”, input 2 and
then 6.
❚
NOTE
• Always enter two digits for the tone number. If you enter only
one digit, the display will automatically return to the previous
tone number setting after a few seconds.
• If you change the tone setting while a keyboard key is
depressed, the tone does not change until you release the key
and press a keyboard key again.
• With certain tones (such as percussion sounds and sound
effects), there may be very little or no change at all in the pitch,
no matter which keyboard key you press.
• If you input the wrong first digit for a tone number, you can
return to the previous setting by pressing the TONE button.
G r a n d P n o
Indicator appears
IMPORTANT!
• Be sure to use the microphone’s ON/OFF switch to turn off
the microphone and to disconnect the microphone from
the keyboard whenever you are not using it.
Recommended Microphone Type
• Dynamic microphone (standard plug)
IMPORTANT!
• Be sure to disconnect the microphone from the keyboard
whenever you are not using it.
Howling (Feedback Noise)
Any of the following conditions can cause howling (feedback
noise).
• Covering the head of the microphone with your hand
• Positioning the microphone too near to a speaker
Should howling occur, try grasping the microphone further
away from the head, and move away from any nearby
speaker.
Static Noise
Fluorescent lighting can cause static noise in the microphone
signal. When this happens, move away from the lighting you
suspect may be causing the static.
A c o . B a s s
LK-1261_e_14-21.p65
04.6.15, 3:33 PM
Page 15
Adobe PageMaker 6.5J/PPC
Summary of Contents for 42-4068
Page 42: ...648U E 042A LK 1261_e_A1 A5 p65 04 6 15 3 34 PM Page 6 Adobe PageMaker 6 5J PPC...
Page 43: ...648U E 043A LK 1261_e_A1 A5 p65 04 6 15 3 34 PM Page 7 Adobe PageMaker 6 5J PPC...
Page 44: ...648U E 044A LK 1261_e_A1 A5 p65 04 6 15 3 34 PM Page 8 Adobe PageMaker 6 5J PPC...
Page 45: ...648U E 045A LK 1261_e_A1 A5 p65 04 6 15 3 34 PM Page 9 Adobe PageMaker 6 5J PPC...
