11
TELEPHONE OPERATION
SETTING THE
TONE-PULSE SWITCH
Set
TONE-PULSE
for the type of ser-
vice you have. If you are not sure
which type you have, do this test:
Lift the handset and set
TONE-PULSE
to
TONE
. When you hear the dial tone,
press any number other than
0
.
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access code
either.
If the dial tone stops, you have touch-
tone service. Leave
TONE-PULSE
set
to
TONE
.
If the dial tone continues, you have
pulse service. Set
TONE-PULSE
to
PULSE
.
SETTING THE RINGER
To turn off the telephone’s ringer, set
RINGER
to
OFF
. You can still make out-
going calls and, if you hear an exten-
sion phone ring, you can still answer
calls. To turn on the telephone’s ringer,
set the
RINGER
to
ON
.
USING REDIAL
To dial the last number dialed, lift the
handset. When you hear the dial tone,
press
REDIAL/PAUSE
. The phone dials
the last number dialed.
Note: The TAD-724’s redial memory
holds up to 32 digits.
USING FLASH
Use
FLASH
to perform the switchhook
operation for special services, such as
Call Waiting.
43-724A.fm Page 11 Tuesday, May 16, 2000 4:51 PM
