24
Notes:
• If you enter the correct code several times, but the TAD does not accept it,
the code might have reset because of low battery power. Try entering 500
(the default) as the security code. If this works, replace the TAD’s backup
battery and reset the remote operation security code as soon as you return
to the TAD’s location (see “Setting the Day and Time” on Page 15 and
“Changing the Remote Operation Security Code” on Page 22).
• If you have CPC service and hang up while the TAD is playing back mes-
sages, it immediately stops playback and resets to answer the next call.
• If you do not have CPC service and hang up while the TAD is playing back
messages, the TAD might not recognize that you hung up. If someone calls
while the TAD continues playing messages, the caller hears a busy signal.
We recommend that you play all the messages or skip forward through the
messages until the TAD beeps before you hang up.
• After you enter the correct security code, the TAD announces the number of
messages recorded and beeps twice. Then the TAD announces the options
from “Remote Commands” on Page 23. When you enter a remote com-
mand, the TAD repeats it for verification and waits 10 seconds for another
command. If you do not enter another remote command, the TAD hangs up
and waits for the next call.
• Press
to stop remote access. Otherwise, the TAD will remain in use for
about 1 minute.
0
Stop message playback, including incoming messages, memos
and the OGM recording.
Hang up. The TAD announces, “The machine will now hang up.”
Press:
To:
43-724A.fm Page 24 Tuesday, May 16, 2000 4:51 PM
