9
REPLACING THE REMOTE
CONTROL’S BATTERY
When the remote’s range is reduced, or if the remote’s indi-
cator does not turn on when you press a button, follow these
steps to replace its battery with a fresh 12-Volt remote battery
(RadioShack Cat. No. 23-144).
Note: We recommend you change the remote’s battery in-
doors on a flat surface, as it involves keeping track of small,
easily lost parts.
1. Lay the remote face down on a flat surface, then use a
small Phillips screwdriver to remove the two screws on
the remote’s back cover.
2. Carefully remove the remote’s back cover.
Note: Leave the remote laying face down on a flat sur-
face. If you turn over the remote, the buttons fall out.
3. Remove the battery.
4. Place the new battery between the power contacts,
according to the polarity symbols (+ and –) marked in the
remote’s case.
5. Replace the back cover and secure it with the screws
you removed in Step 1.
49-805.fm Page 9 Thursday, August 19, 1999 9:51 AM
