Need help? Call 1-800-950-7044!
49
IF YOU HAVE PROBLEMS
SEARCHING THE CODE LIBRARY
If the 6 in 1 RF Remote Control System’s remote con-
trol does not operate your remote-controlled devices
when you first set it up, you probably haven’t entered
the correct 3-digit codes for your devices. You can try
all the codes for the brand of your device, but because
many manufacturers make products using several dif-
ferent brand names, you might want to search the sys-
tem’s entire library by following these steps.
1. Manually turn on the device you are trying to set
up, then press the appropriate device key on your
system’s remote control.
2. Aim the system’s remote control at the device.
3. Press and hold down
SET UP
until the red indica-
tor blinks twice. Release
SET UP
and press
9 9 1
.
The red indicator blinks twice.
4. After the two blinks, repeatedly press
PWR
, then
the device key for the type of device. For exam-
ple:
PWR TV PWR TV PWR ...
Each time you press the device key, the remote
control advances to the next manufacturer’s code
in its library.
5. When the device responds, press and release
SET UP
to lock in the manufacturer’s code.
If necessary, repeat these steps for each device key.
VIEWING A DEVICE’S CODE
To determine which 3-digit code the system’s remote
control is set to, press the device key, then hold down
SET UP
until the red indicator blinks twice. Release
SET
UP
and press
9 9 0 1
. The system blinks out the num-
ber of the first digit of the manufacturer’s code.
Note: The red indicator light does not blink if a digit in
the code is a zero.
Press
2
to see the second digit of the manufacturer’s
code, and
3
to see the third digit.
15-1919.fm Page 49 Monday, July 19, 1999 12:34 PM
