8
Desolder with the Desoldering Pump
Bridge
A
bridge
forms if solder
fl
ows over the
board, connecting two pads that should
not be connected.
1
2
3
2
1.
Hold the desoldering tool
fi
rmly and push the plunger down until it clicks.
2.
Reheat the bridge until it becomes liquid.
3.
Hold the pump to the melted solder and press the trigger button.
Note:
To extend the life of the tip, press it lightly to the work area.
4.
Push the plunger down again to eject the solder into a metal, glass or
ceramic receptacle. Do not reuse this solder.
Caution:
• Always keep the tip end of tool away from your face.
• Never point the tool at another person.
• Do not let ejected solder fall onto PCBs or other wiring, as this may cause
a short circuit.
