18
• When the TAD is set for announce-only, you cannot set it to
record incoming messages using the remote commands.
• If you set
INCOMING MSG
to
ANN ONLY
but did not record
an announce-only OGM, you can do so remotely. The TAD
answers the phone after 10 rings and beeps twice. Enter
the remote security code (see “Remote Operation Security
Code” on Page 23). Within 7 seconds, enter the remote
command
8#
to begin recording your OGM. To stop record-
ing, enter
5#
. Your announce-only OGM automatically plays
back once. The TAD answers subsequent calls according
to the ring select switch, then it plays your announce-only
OGM.
To turn off the announce-only feature so callers can leave mes-
sages, slide
INCOMING MSG
to either
1
or
5
MIN
.
SCREENING CALLS
To screen your calls, let the TAD answer. Listen to the caller's
message through the TAD's speaker. If you decide to answer
the call, pick up any phone connected to the same phone line
as the TAD. The TAD stops recording and resets to answer the
next call.
RECORDING A MEMO
A memo is a message that you record by speaking directly into
the TAD, without calling in on the phone. Follow these steps to
record a memo up to 1 or 5 minutes as set by
INCOMING
MSG
.
43-3801.fm Page 18 Friday, April 21, 2000 9:25 AM