Need help? Call 1-800-955-2599
6
Note: Do not place objects on top of the remote
control after you install the batteries. This can
press down keys and reduce battery life.
SETTING UP YOUR REMOTE
CONTROL
1. Refer to “Manufacturers’ Codes” on Page 10
and write down the codes for your original
remote controls on the provided label.
2. Press the device key for the type of remote
you are replacing (
TV
,
VCR
, or
CBL
).
3. Hold down
P
until the red indicator blinks
twice, then release
P
and enter the 3-digit
manufacturer’s code.
For example, to replace a Panasonic TV’s
remote control (manufacturer code 051), you
would press:
TV P 0 5 1
4. When the indicator blinks twice again, point
the 3 in 1 at your device and press
PWR
. The
device should turn on (or off, if it was on).
Repeat these steps for additional devices.
Notes:
• The punch-through feature is automatically
turned on for the TV’s volume and mute con-
trols. This means that when you select
CBL
and press one of the volume buttons or
MUTE
, the remote actually sends the codes
to the television to control it, not the cable
converter. If you want to use your cable con-
verter’s volume and mute controls, disable
the punch-through feature for these buttons.
See “Punch Through” on Page 8.
15-1916b.fm Page 6 Monday, July 19, 1999 12:17 PM