17
USING HOLD
To put a caller on hold, press
HOLD
. The
HOLD indicator on the corded phone
flashes and you can hang up the hand-
set without disconnecting the call. Or, if
you are using the headset, press
HOLD
on the infrared remote dial card.
To resume the call, lift the handset, pull
down on the microphone until it clicks, or
pick up any extension phone on the
same line.
Note: If another extension is in use on
the same line, the IN USE indicator on
the corded phone flashes red and the IN
USE/BATT. LOW indicator on the head-
set flashes green.
USING TONE SERVICE ON
A PULSE LINE
If you have pulse service, you can still
use special services that require tone
signals, such as bank-by-phone, by fol-
lowing these steps.
1. Be sure
TONE/PULSE
is set to
PULSE
.
2. Dial the service's main number.
3. When the service answers, press
. Any additional numbers you
dial are sent as tone signals.
4. When you hang up, the phone auto-
matically resets to pulse mode.
MEMORY DIALING
Your ET-007 has one direct memory
(00) location and twenty indirect memo-
ry locations (01–20) for storing frequent-
ly used phone numbers. Each number
can contain up to 20 digits.
Note: Memory storing can only be pro-
grammed using the corded phone.
Storing a Number In Memory
1. Be sure the phone is not in use,
then press
PROGRAM
.
2. Enter the 2-digit memory location
(
00
for the direct memory, or
01
to
20
for indirect memory). The phone
rings.
HOLD
43-007.fm Page 17 Wednesday, March 22, 2000 11:24 AM
