1997, 1998 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
MOUNTING THE PHONE
Desk Mounting
Wall Mounting
(With or Without Wall Plate)
USING THE PHONE
ÐÐ
Set the ringer to sound or not. You can
make calls with the ringer off, and you
can receive calls if you hear another
phone on the same line ringing.
Switch to
TONE
or
PULSE
to match the type of
service you have. If you have pulse (rotary) ser-
vice, you can switch to
TONE
during a call to
use tone services.
Note: If you do not subscribe to any special ser-
vices, pressing
FLASH
might disconnect the call.
Press
FLASH
to produce a timed switchhook sig-
nal for special services such as Call Waiting.
Press
REDIAL
to dial the last number dialed
(up to 31 tone or 32 pulse digits).
Press to hang up.
Plug the handset cord into
the jacks on the handset
and base.
Press
RESET
to end a call without returning the
handset to the cradle.
Press for special services.
Use the memory index card
to record important phone
numbers.
This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C (RJ11W for a wall jack).
Modular
Telephone
Jack
Short
Line Cord
(supplied)
Handset Holder (Wall Mounting)
Slide the clip up, rotate it 180°, then
slide it back into the slot.
