O
WNER
’
S
M
ANUAL
CHECKING THE CODES
If you have set up the RadioShack 4-in-One Remote using the
Searching For
Your Code
procedure (on the previous two pages), you may need to find out
which four-digit code is operating your equipment. For example, to find out
which code is operating your TV:
1. Press and hold
P
until the bottom IR segment flashes twice. The program
keys will appear:
2. Press above
OTHER
once. The
Other
programming screen will appear:
3. Using the number keys, enter
9 9 0
. The bottom IR segment will flash
twice and the
Code Verification
screen will appear.
4. Press a desired device key once (i.e.,
VCR
,
TV
,
CBL/SAT
, or
DVD
). The selected
device key will animate.
5. To view the code for the first digit, press
1
once. Count the number of
times the bottom IR segment flashes (e.g., three flashes = 3) and write
down the number in leftmost box in the TV code boxes on page 11.
NOTE
: If a code digit is “0”, the bottom IR segment will not flash.
6. Repeat step 5 three more times for remaining digits. Use
2
for the second
digit,
3
for the third digit, and
4
for the fourth digit.Write down the code
digits in the remaining TV code boxes on page 11.
NOTE
: If you enter an invalid number (e.g.,
7
) or key (e.g.,
PLAY
), the bottom IR
segment will display one long flash and return to the “Other” programming screen.
Start again with step 2.
7. To check for codes of other devices, repeat steps 4 to 6 , but substitute the
appropriate device key for each device you are checking.Write down the
device’s code digits in the appropriate code boxes on page 11.
8. To exit programming, press
twice. The display will return to the last-
selected device menu screen.
Checking The Codes
15
RS 4in1 Kameleon OM rev 8/19/03 8:42 PM Page 15
