8
Using Vehicle Battery Power
To power your scanner from your ve-
hicle’s battery power, you need a DC
power cord (such as Radio Shack
Cat. No. 270-1533).
Cautions:
• Your vehicle must have a 12-volt
DC, negative-ground electrical
system.
• The recommended DC power
cord supplies 12 volts and deliv-
ers at least 500 milliamps. The
center tip on the barrel plug is
set to positive, and the plug
properly fits the scanner’s
DC
12V
jack. Using a DC power cord
(or adapter) that does not meet
these specifications could dam-
age the scanner or the cord (or
adapter). The scanner’s display
dims if the DC cord (or adapter)
you use does not provide the
required 12 volts DC.
• Be sure you connect the DC
cord to the scanner before you
connect it to the vehicle’s ciga-
rette-lighter plug. Then discon-
nect the cord from the vehicle’s
cigarette-lighter plug before you
disconnect it from the scanner.
Follow these steps to use vehicle
battery power.
1. Insert the barrel plug into the
scanner’s
DC 12V
jack.
2. Plug the other end of the
adapter into your vehicle’s ciga-
rette-lighter socket.
Note: If the scanner does not oper-
ate properly when you use a DC cord
(or adapter), unplug the cord (or
adapter) from the lighter socket and
clean the socket to remove ashes
and other debris.
DC 12V Jack
20-414.fm Page 8 Wednesday, August 4, 1999 11:12 AM