77
Beyond the Basics
To clear Error, press ./CLR.
Once you have fi nished cloning the scanners, reset them
by turning them off then on again. This is important if you
wish to clone another scanner right away.
birdies
All radios can receive birdies (undesired signals). If your
scanner stops during scan mode and no sound is heard, it
may be receiving a birdie. Birdies are internally generated
signals inherent in the electronics of the receiver.
Press L/O to lockout the channel, and then press
HOLD/RESUME to resume scanning.
replacing the fuse in the DC power cord
The fuse in the DC power cord helps protect your scanner
from power surges and short circuits. If the fuse in the DC
power cord has blown, replace it with a 1-amp, fast-acting
glass fuse.
Before you begin, turn off the scanner and your vehicle’s
ignition.
Make sure you replace the fuse only with another fuse of
the same type and rating.
1. To open the fuse holder, push the fuse holder ends
together, and then turn either end counterclockwise and
release it.
2. If the fuse is blown, replace it.
3. To close the fuse holder, push the fuse holder ends
together, then turn either end clockwise.
Notes
Notes
Notes
Notes
