36
7. While S in Step blinks, repeatedly press
π
or
θ
to select the step number, 5, 6.25, 7.5,
12.5, 15, 25.0, or 50.0kHz, then press ENTER.
Programming Motorola 800 MHz Splinter Systems
Certain 800 MHz Motorola trunked radio systems operate using splinter channels that
are in between the channels in the normal 800 MHz band plan. These systems are
known as
splinter systems
. Your scanner features an offset mode to allow reception of
these systems.
Notes
•
If the radio appears to be trunking to the wrong frequencies when monitoring an 800
MHz system, you should try to configure the system for splinter operation.
•
Splinter systems exist only in the 800 MHz band, and only use the 3600 baud control
channel type. Setting splinter configuration on VHF, UHF, 900 MHz and 800 MHz
APCO-25 systems will have no effect.
1. Press PGM then TRUNK to enter the ID program mode.
2. If necessary, press FUNC then
π
or
θ
to select the desired bank.
3. If necessary, press MODE to select Motorola trunking mode.
4. Press FUNC then 3 to edit the 3600 CC Mode.
5. Press
π
or
θ
to select
Normal
or
Splinter Table, Multi Table
and press
ENTER.
Programming Fleet Maps
You must set the fleet map if you want to receive a Motorola Type I system. Fleet maps
are included along with other information about Motorola Type I systems at
www.trunkscanner.com
.
Follow these steps to program a fleet map.
1. Press PGM then TRUNK.
