86
2. Press
π
or
θ
to select None, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, or 4.0 seconds.
3. Press ENTER.
Hint
•
Most Motorola trunking systems include a “hang time” where the channel remains
assigned to a talkgroup for a short period after the user unkeys their microphone.
This hang time is typically 1.5 seconds but can vary among different systems. The
scanner’s trunked delay function begins after this hang time expires. Therefore, the
total amount of delay present after a user unkeys their microphone equals the
trunking system hang time, plus any trunked ID delay that you have programmed into
the scanner. For example, if you wish to wait a total of two seconds for a reply trunked
call, and the system you are monitoring is using 1.5 seconds of hang time, you should
set the trunked delay for that system to 0.5 seconds. EDACS systems do not employ
hang time.
•
Conventional channel delay is fixed at 2 seconds and is controlled independently of
trunked ID delay. Refer to “Using the Delay Function” on Page 65 for more
information.
Clearing Talkgroup Ids
You can clear IDs from the ID list to make room for new IDs.
1. Press PGM then TRUNK.
2. Press FUNC,
π
or
θ
to select an ID memory.
3. Press FUNC then CLR to clear the contents of the selected ID.
Clearing All Talkgroup IDs in One Bank
You can clear all talkgroup IDs within a bank. This lets you quickly delete all talkgroup
IDs from a bank if you want to use the bank to store different data (such as a new set of
talkgroup IDs).
1. Press PGM.
