1
cable and software (available at your local
RadioShack
store or www.radioshack.com).
1. Make sure your scanner is turned off.
2. Connect the interface cable to your computer
and then connect the other end of the cable
to PC/IF on the side of the scanner.
3. Install the software to your computer and run
the program.
4. Set up the program according to the software
directions.
5. Turn the scanner on. The scanner automatically
goes into the wired programming mode.
6.
WIRED PROGRAMMING MODE
appears when the
scanner receives data from the PC.
7. After completing the programming, turn the
unit off, then remove the cable. Turn the unit
on again.
Settings
Delay
Sometimes a radio caller might pause before
replying to a transmission. To avoid missing
a reply on a specific channel, the scanner
automatically programs a 2-second delay into
any channel or frequency. You can monitor the
channel frequency for an additional two seconds
after the transmission stops before resuming
scanning or searching.
Depending on the scanner operation, follow one
of these steps to turn on or off a delay.
• To turn off the 2-second delay, press
Func
+
2
ABC
/DLY
while the scanner is monitoring a
channel or searching.
DLY
disappears.
• To turn on the 2-second delay to a channel
Summary of Contents for RPO-137
Page 42: ...42 Notes...
Page 43: ...43 Notes...