For Assy:
MINITIE12-8
MINITIE6-8
Rev: 01/05
St Model MINITIE6-8 & MINITIE12-8
Engineered for Inter-Studio Tie Lines
General
Mini Tie Hubs provide multi-pair inter-studio connectivity by
splaying out CAT-5 25 pair cable to individual RJ-45
connectors via a 50 pin RJ-21 mass connector. Mini Hubs are
designed to mount and fit where the capacity of full-size hubs
is not needed. Depending on the model selected, either 2 or
4 CAT-5 pairs are connected to each RJ-45 connector.
Double the density is achieved if only 2 pairs (4 wires) are
required to connect to each RJ-45. Generally, 2 pair is
sufficient to support StudioHub analog and digital audio
circuits. All 4 pairs (8 wires) are needed to support KVM and
other special multi-wire equipment circuits.
Mounting
Mini tie-line hubs are available in single units on small wall-
mountable plates, or in double density on 1 r.u. rack mounts
Grounding Information.
RJ-45 connector shields are common on the mini tie hubs.
Two jumpers are provided that allow the unused CAT-5 25
th
pair to be connected to this common shield, as well as to the
hub chassis.
Each RJ-45 provides 8
wires of connectivity via
the CAT-5 25-pair cable
Name
MINITIE6-8 / MINITIE12-8
Mount
Wall Mount / Rack Mount (1 r.u.)
Channels
6/12
CAT-5 Pairs
8 (all)
Power Link
no
Connectors
RJ-21, RJ-45
Versions
Plate, Rack
Product Key
8
7
6
5
4
3
2
1
Shield
RJ- 45
Hub
Chassis
Ground
JU2
J4
J1
JU1
Unused
Pair
x 12
or 6
RJ-21
Each RJ-45 provides 8
wires of connectivity via
the CAT-5 25-pair cable
RJ-21 connects 25-pair CAT-5 cable
carrying six 4-pair circuits. One 25-pair
CAT-5 cable is required for 6 circuit
model. Two 25-pair CAT-5 cables are
required for 12 circuit model.
Insert jumper to tie
power supply shield to
hub chassis ground
Insert jumper to tie
power supply shield to
hub chassis ground
Model - MINITIE6-8
Model - MINITIE12-8
Radio Systems, Inc.
•
601 Heron Drive
•
Logan Twp., New Jersey 08085
(856) 467-8000
•
Fax (856) 467-3044
•
www.studiohub.com
bl
