How it works:
The Indoor Radio Fence is a simple to operate system designed to keep
pets away from a designated area specified by the user. The system can
be used to keep you pet away from a certain room, away from a sofa,
table top, etc., by simply placing the transmitter near the doorway or
under the sofa. Although the transmitter is designed for indoor use, it
can be used in the garage or under a covered patio where a 110 outlet
is accessible.
Caution: To avoid the risk of electrical shock and damage to the transmit-
ter - Do not use on wet surfaces, in damp or wet locations, or around
swimming pools. Do not expose to rain or snow to avoid damage to
the unit.
1. Components:
• Receiver (optional)
• Transmitter
• Adaptor
• Owners Manual
2. Operating the receiver
Assemble Collar. Measure your pet’s neck, mark the appropriate length,
making sure you leave enough slack for the probes and any growth your
pet may experience. Trim the excess off collar.
Seal the edge of the cut by taking a
match or lighter along the frayed edge.
When threading your strap through
the clasp, loop the collar through the
clasp exactly like the illustrations above.
Installing batteries in receiver.
Install one 6 volt battery observing
proper polarity. Reinstall lid a tighten
both screws securely.
Note: It is important to check your batteries to insure proper operation of
your system. Battery life will vary depending on how often your pet tests
the system and receives a correction.
Placing the receiver on your pet
Place the receiver collar on your pet directly beneath the neck. Attach
securely enough that the probes make contact with the skin. You should
be able to fit one finger between the probes and your pet’s neck.
Important Note: Slide buckle also
prevents collar from becoming loose
around your dog's neck.
Important Note: Ribs must be
facing up, otherwise collar will slip
if it is not proberly threaded.
2
