21
e. Enter RX frequency (Ex. 43266250)
f.
[MENU] [2][8] [MENU] [1][0] [MENU]
Enter the desired channel (Ex 10)
-->> [EXIT]
Channel has been added
g.
Press and hold the
[MENU]
key to return to the MR mode and the channel number will reappear.
6.11 Repeaters Programming
The following instruc
�
ons assume that you know what transmit and receive frequencies your repeater employs, and that
you're authorized to use it.
a.
Press and hold the
[MENU]
key to set the radio to VFO mode, and the VFO icon is displayed on the right.
b.
Use the numeric keypad to enter the repeater's output (your receiving) frequency.
c.
Press the
[MENU]
key to enter the menu.
d.
Enter
[2][7]
on the numeric keypad to get to frequency o
ff
set.
e.
Press
[MENU]
key to select.
f.
Use the numerical keypad to enter the speci
fi
ed frequency o
ff
set. See the sec
�
on called “27 OFFSET - Frequency shi
�
amount” for details.
g.
Press
[MENU]
to con
fi
rm and save.
h.
Enter
[2][6]
on the numeric keypad to get to o
ff
set direc
�
on.
i.
Use the
▲
/
▼
keys to select
Plus
(posi
�
ve) or
Minus
(nega
�
ve) o
ff
set.
j.
Press
[MENU]
to con
fi
rm and save.
k.
Op
�
onal:
a). Save to memory, see the sec
�
on called “Manual programming” for details.
b). Set up CTCSS; see the sec
�
on called “CTCSS” for details.
l.
Press
[EXIT]
to exit the menu. If everything went well, you should be able to make a test call through the repeater.
NOTE:
If you're experiencing problems making a connec
�
on to the repeater, check your se
�
ngs and/or go through the procedure
again.
Certain Amateur Radio repeaters (especially in Europe) use a 1750Hz tone burst to open up the repeater. To see how this is
Summary of Contents for GA-5E
