7
Chapter3. Installation of Accessories
Before the radio is ready for use we need to a
�
ach the antenna and ba
�
ery pack, as well as charge the ba
�
ery.
3.1 Installing/ Removing the Antenna
a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by holding the antenna at its
base and turning it clockwise un
�
l secure.
b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.
3.2 Installing the belt clip
a. At the back of the radio there are two parallel screws mounted above the ba
�
ery, remove these and thread them through
the holes on the belt clip as you screw them back into the radio body.
b. Removing the Belt Clip: Unscrew counter-clockwise to remove the belt clip.
3.3 Installing the ba
�
ery pack
Before a
�
aching or removing the ba
�
ery make sure your radio is turned o
ff
by turning the power/volume knob all the way
counter-clockwise.
a.
Make sure the ba
�
ery is aligned in parallel with the radio body with the lower edge of the ba
�
ery about 1-2cm below
