6100-Gfast Multifunction Copper Tester Operation Manual
© 2020 Radiodetection Ltd
173
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options.
4. Press
to confirm the value.
Identification
The
Identification
tab allows you to preset values to
identify each single and auto test result file when saving
them.
The parameters are as follows:
User Name
/
User ID
allow you to enter up to 25
alphanumeric characters, in each field.
Contractor Name
allows you to enter the
name of a contractor used to perform the tests.
Test From
/
To
allows you to select from a list of
entries - up to 20 each, including user defined
values
Test From
/
To List Setup
buttons open
separate list management pages.
To select the parameter values:
1. Press the up/down arrow keys to highlight the
desired parameter.
2. Press the left/right arrow keys to view and
select the options.
OR
3. Press
on a value to open a list box of
options or the alphanumeric editor screen and
use the navigation keys to scroll through.
4. Press
to confirm the value.
Test List Setup
The
Test From List Setup
and
Test To List Setup
pages allow you to manage the entries of the list.
However, there are 5 entries by default which cannot
be edited or deleted. These are
DSLAM
,
NID
,
CPE
,
CROSSBOX
,
FRAME
. When any of these are
selected, the
Delete
and
Accept
buttons are disabled.
A maximum of 20 different entries can be added.
To manage the list:
1. Press the left/right arrow keys to select the
Previous/Next Entry
buttons and press
to
select the previous/next entry.
2. Press
Page Up/Down
function keys to see
entries on the previous or next pages. These
keys are disabled if no other pages exist.
3. Press
Add
function key to add an entry just
below the selected entry in the list.
4. To edit an entry, press the up/down arrow
keys to highlight the selected test. Press
Accept
function key to confirm the changes. If
you press
Previous/Next Entry
buttons
before the
Accept
function key, the edited
value will be lost.
5. Press
Delete
function key to delete any entry
you have added.
