© 2020 Radiodetection Ltd
2
Batteries
WARNING! Only use charging equipment provided by
Radiodetection. The use of alternative chargers may cause
a safety hazard and/or reduce the life of the battery.
CAUTION: Do not let your battery completely discharge
as this may reduce its life or damage it permanently. If
you are not using your equipment for a long period
charge it at least once a month.
WARNING! Batteries can get hot after prolonged use at
full output power. Take care while replacing or handling
batteries.
WARNING! Do not tamper with, or attempt to
disassemble the battery packs.
CAUTION: If battery failure is suspected or if the battery
shows any sign of discoloration / physical damage return
the entire unit to an authorized repair center for
investigation and repair. Local, national or IATA
transport regulations may restrict the shipment of faulty
batteries. Check with your courier for restrictions and
best practice guidelines.
Radiodetection representative will be able to direct you
to our authorized repair centers.
Disposal
This symbol on the product, accessories or
literature indicates that the product and its
electronic accessories (e.g. charger, headset,
USB cable) must not be treated as domestic
waste, but must be disposed of professionally.
It is your responsibility to dispose of your waste
equipment by handing it over to a designated collection
point for the recycling of waste electrical and electronic
equipment. The separate collection and recycling of your
waste equipment at the time of disposal will help to
conserve natural resources and ensure that it is recycled
in a manner that protects human health and the
environment. For more information about where you can
drop off your waste equipment for recycling, please
contact your local city office, your disposal service or
product supplier.
Please dispose of this device in a manner appropriate to
the relevant legal requirements at the end of its product
life
Batteries should be disposed of in accordance with your
company’s work practice, and / or the relevant laws or
guidelines in your country or municipality.
Special Bluetooth
®
notice
RD8200 locators and transmitters contain a Class 1
Bluetooth device that can emit radio frequency energy
during the operation of certain product features. While
the Bluetooth device is busy, pairing or sending iLO
C™
commands from the locator to the transmitter, or sending
survey measurements to a paired device, always ensure
a minimum separation of 200mm (8 inches) between the
Bluetooth antenna and your body. The location of the
antenna is shown in Section 3, figure 3.1.
Wireless technology compliance
Use of iLOC wireless technology where applicable may
be subject to national telecommunication regulations.
Check with your local government authorities for further
information.
1.2 Compliance
The Declaration of conformity is available to download
from the RD8200 cable, pipe product section page in
https://www.radiodetection.com/
For EMC and Safety compliance refer to the relevant
Technical specification document, which is available to
download from
the RD8200 cable, pipe product
section page in https://www.radiodetection.com/
FCC Compliance Statement
This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
The equipment may not cause harmful
interference.
The equipment must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply
with the limits for a Class A digital device pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accorda
nce with the manufacturer’s instruction manual,
may
cause
harmful
interference
with
radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in
which case you will be required to correct the
interference at your own expense.
Modifications
: Any modifications made to this
equipment not approved by Radiodetection may void the
authority granted to the user by the FCC to operate this
equipment.
Industry Canada Compliance Statements
ICES-003 Class A Notice:
This Class A digital apparatus complies with Canadian
ICES-003.
Avis NMB-003, Classe A:
Cet appareil numérique de la classe A est conforme à la
norme NMB-003 du Canada
