© 2020 Radiodetection Ltd
49
Figure 12.13: Phone/tablet mount kit
To use the mobile device mount:
Figure 12.14: Bracket positioning
1 Insert the mount bracket locating pins in the
mounting holes at the back of the locator screen
2 Secure the rubber o-ring around either of the 2 fixing
studs and loop it around the locator handle
Figure 12.15: Bracket secured
3 Stretch the other end of the rubber o-ring over the
remaining fixing stud as for Figure 14.15
4 Use the hand tightening bolts to loosen up the arm
brackets and to attach it over the bracket’s arm
support ball.
5 Add the phone or tablet holder
6 Tighten the hand tightening bolts to secure the
mount
7 Position the phone or tablet to the front of the locator
as shown in Figure 14.16
Figure 12.16: Phone/tablet correct position
WARNING: Mobile phones or tablets may interfere
with the locator’s performance if positioned not in front of
the locator, see picture 14.16
Some mobile phone or tablets may affect the locator’s
performance, even if used in the correct position. This
may be obvious in situation where the locator is trying to
detect a very small signal and it manifests itself by an
unstable signal shown on the bargraph and/or depth or
current measurement.
If in doubt remove the mobile phone or tablet to verify if
these are affecting the behavior of the locator.
No cables, such as power leads or headphones, must
be connected to the phone or tablet when used with the
mount kit.
rubber o-ring
mount bracket
arm bracket
hand tightening bolts
fixing
stud
arm
support
ball
fixing
stud
locating
pins
phone holder
tablet holder
