52
This function may also be used to create a “slowed servo” on a channel other than throttle. This is accomplished by
plugging the desired servo (Ex: gear doors) into CH3 (
THR
), throttle into an auxiliary channel such as 8, and then using
VRPHFUHDWLYHPL[HV3OHDVH
contact us
DWZZZ
radiolink.com.cn/doce/
IRUWKLVVSHFL¿FH[DPSOH
GOAL of EXAMPLE:
STEPS:
INPUTS:
Activate
THR-DELAY
for a ducted-fan
replica of a turbine-powered aircraft.
Slow the servo response byone second.
Open the
THR-DELAY
function.
for 1 second.
(If
BASIC
,
again.)
C
to
THR-DELAY
.
Activate the function.
C
to
MIX
.
to
ACT
.
Adjust the
RATE
to match the desired
servo speed. (Ex:
40%
.)
C
to
RATE
.
to
40%
.
Close menu.
Where next?
Set up
THROTTLE-NEEDLE
mixing: see p. 50.
Adjust throttle’s
END POINT
: see p. 27.
Adjust throttle exponential (
D/R
,
EXP
): see p. 30.
Set up
AILEVATOR
: see p. 44.
Set up programmable mixes, for example,
RUDDER-AILERON
: see p. 55.
View
more
on the internet: www.
radiolink.com.cn/doce
Throttle curve (
THR-CURVE
)(
ACRO
):
This function adjust the throttle operation curve for optimum the engine speed
to throttle stick movement.
NOTE: If the throttle
EXP
function is activated, you can not use
THR-CURVE
function simultaneously.
Adjustability:
• Separate curves for each switch position are available.
•
Moving and deleting the curve point
: The curve point (
-stk-
) can be moved to the left or right by turning the
DIAL
(up to
LQIURQWRIWKHDGMRLQLQJSRLQWDQGGHOHWHGUHWXUQHGE\SUHVVLQJWKH
DIAL
for one second alternately.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Base point:
Adjust base point of throttle
curve until engine idles reliably.
-out-
: output, servo position.
-stk-
: curve point, stick position.
Open the
THR-CURVE
function.
for 1 second.
(If
BASIC
,
again.)
C
to
THR-CURVE
.
Activate the function.
C
to
MIX
.
to
ON
.
$GMXVWWKH¿UVWSRLQW
C
to point 1 (
-out-
).
to desired
throttle servo position.
Optional: Assign the switch.
C
to
SW
.
to desired switch.
Optional: Move the curve point.
(Ex: point 3)
C
to point 3 (
-stk-
).
to desired
curve point to move to left or right.
Optional: Delete the curve point.
And return the curve point.
(Ex: point 3)
C
to point 3 (
-stk-
).
for one
second to delete the curve point.
C
to point 3 (
-stk-
).
for one
second to return.
Next point:
Adjust the next point.
Repeat as needed.
Close.
