12
4.
Adjusting Display Contrast: To adjust the display contrast, from the home menu press and hold the END
BUTTON. Turn the DIAL while still holding the END BUTTON: clockwise to brighten and
counterclockwise to darken the display.
5.
User name setting: user name can be set by DIAL and PUSH with letters and numbers.
6.
Alarming voltage:
Transmitter: preset 8.6V, can be self-set
Receiver: preset 4.0V, can be self-set
Ext: preset 10.1V, can be self-set
1.3.2 Model type
Under basic menu, use DIAL to select MODEL TYPE and enter by pressing PUSH. There are 6 different
type included in the system, HELICOPTER, AEROBASIC, GLID(1A+1F), GLID(2A+1F), GLID(2A+2F),
and AIRCRAFT, after model type is selected, press and hold PUSH for 1 second, when the word “are you
sure to change” displayed, model type is changed.
1.3.3 Bind
Each transmitter has an individually assigned, unique ID code. In order to start operation, the receiver must
be linked with the ID code of the transmitter with which it is being paired. Once the link is made, the ID
code is stored in the receiver and no further linking is necessary unless the receiver is to be used with another
transmitter. When you purchase another R6014FS, this procedure is necessary; otherwise the receiver will
not work.
1. Place the transmitter and the receiver close to each other within one (1) meter.
2. Turn on the transmitter.
3. Press and hold ID SET switch of the receiver one second, now the indicator LED will start blinking. It
will automatically find the nearest transmitter to bind, which is an outstanding feature for R9D receiver.
4. Test with servo to make sure the binding is finished.
1.3.4 S.BUS
Short press the ID SET switch two times within 1 second, the signal is changed from normal PWM to
S.BUS. The blue LED indicates the normal PWM and red S.BUS.
1.3.5 Transmitter Displays & Buttons
When you first turn on your transmitter, a confirmation double beep sounds, and the screen shown below
appears. Before flying, or even starting the engine, be sure that the model type and name appearing on the
display matches the model that you are about to fly! If you are in the wrong model memory, servos may be
reversed, and travels and trims will be wrong, leading to an immediate crash.
Startup screen
Total timer
:
Shows the cumulated ON time.(hours: minutes)
T1/T2
:
T1/T2 timer display.(minutes: seconds)
MT
:
Model timer display Shows the cumulated ON time for each model.(hours: minutes)
Button instruction
MODE BUTTON: