55
• Throttle cut feature also moves the in flight needle servo.
• The CH8 knob adjusts the high throttle mixture (may be deactivated. see AUX-CH).
• Because both use CH8, this function cannot be used simultaneously with AILEVATOR.
• An acceleration (ACCE) function (ACRO only) helps the engine compensate for sudden, large amounts of
throttle input by making the mixture suddenly richer, then easing it back to the proper adjustment for that
throttle setting. This function requires some adjustment to best fit your engine and your flying style. Adjust
engine's response until no hesitation occurs on rapid throttle input.
• Separate curves are available (HELI only) for normal, idle-ups 1 and 2 combined, and idle-up 3. Immediately
below MIX the radio displays the curve you are editing; ex: >NORML; and then which condition is currently
active by your switches ex: (ID1/2). Note that you can edit the mix for a different condition without being in that
condition, to allow editing without having to shut off the helicopter’s engine every time. Be sure you are editing
the proper curve by checking the name after the > and not the one in parentheses.
Goals
Steps
Inputs
Activate
THROTTLE-
NEEDLE mixing.
Adjusting the points
as follows: to
resolve a slight lean
midrange problem:
1
：
40%
2
：
45%
3
：
65%
4
：
55%
5
：
40%
Open THROTTLE-NEEDLE
to BASIC .
again to ADVANCE
to THR-NEEDLE,
Activate the function.
to MIX.PUSH
to ON.
HELI only. Select the condition
to edit.
to COND.PUSH.
as needed.
Adjust the travels as needed to
match your engine by slowly
moving the stick to each 5
points, then adjusting the
percentage at that point until
the engine is properly tuned.
to PIONT.
Throttle Stick to P
1
，
to40%
，
Throttle Stick to P
2
，
to 45%
，
Throttle Stick to
P 3
，
to 65%
，
Throttle Stick to
P 4
，
to55% ,
Throttle Stick to
P 5
，
to 40%,
ACRO only . Optional: increase
mixture when throttle is applied
rapidly-ACCE.(see above for
details)
to ACCE. Push
Throttle Stick to idle
Throttle Stick to full open quickly.
Heli only: set curves for another
conditions.
to condition name
to next condition name to
edit.
Repeat above steps as needed.
Close
