58
3.2.1 Programmable MIX
The setting of Programmable MIX of glider is the same with that of acrobasic. Click here or go to page 39 to
check the detailed setting method.
3.2.2 FLAPERON
The setting of
FLAPERON
of glider is the same with that of acrobasic. Click here or go to page 43 to check
the detailed setting method.
3.2.3 V-TAIL
The setting of
V-TAIL
of glider is the same with that of acrobasic. Click here or go to page 51 to check the
detailed setting method.
3.2.4 OFFSET
Additional flight conditions are available specifically for sailplanes.
These additional flight conditions contain different offset trims to
make the sailplane perform certain maneuvers more easily.
Aileron differential functions may be set to provide separate rates
per condition selected.
Prior to setting up OFFSET, you must active the conditions and
assign the switches in the CONDITION/FUNCTION.
Unnecessary fuselage motion is generated when there are
sudden changes in the servo position and variations in the
operating time between channels can be suppressed by using the delay function.
Note: The same delay amount for elevator and rudder is recommended when using V-tail function.
The AT9 provides 5 additional setups along with the normal flight condition. (NORMAL,
START, SPEED, DISTANCE and LANDING) These offset trims have same setting abilities basically except
the switch and dial assignment. For an example of trim settings, please see the following:
Adjustability:
• Separate adjustments for each aileron, elevator, rudder and flap servo, for each condition.
• SWITCH G (AT10) or E (AT10) is programmed for NORMAL, START, and SPEED trims. SWITCH C is
programmed for DISTANCE and LANDING trims. These switch/position assignment is adjustable.
(CONDITION/FUNCTION)
• TRIM item (Digital trim operation mode):
NORM: normal trim operation mode.
MIX: offset rate trim operation mode while mixing is on.
• Optional assignable knob (CAMBER MIX) to allow trimming in flight of the aileron and flap action of each
flight condition.
• During OFFSET operation, the aileron and elevator travels are displayed on each trim display in the Startup
screen.
