深圳市乐迪电子有限公司
67
3.3.3 GYRO SENSE
About GYRO SENSE, there are two types: STD and GY. please refer to
3.3.12, by following steps:
3.3.4 REVO MIX
This 5-point curve mix adds opposite rudder input to counteract the changes in torque when the speed and
collective pitch of the blades is changed.
Adjustability:
• Three separate curves available: normal for hovering; idle-ups 1 and 2 combined; and idle-3.
• Normal condition curves are editable in the BASIC menu for convenience.
• All curves may be adjusted in the ADVANCE menu.
• Correct mix is automatically selected in-flight with each condition and automatically activated when the
throttle setup for that condition is activated in the programming (i.e. THROTTLE HOLD or THR-CURVE.)
• To change which condition’s curve is being edited, cursor up above POINT5 and select. For clarity, the name
of the condition currently active (switched on at the radio) is shown in parentheses behind the name of the
condition whose curve is being edited.
Revo. Mixing rates are 5-point curves. For a clockwise-turning rotor, the rudder is mixed in the clockwise
direction when collective pitch is increased; for counterclockwise-turning, the opposite. Change the operating
Goals
Steps
Inputs
Set up heading-
hold /AVCS gyro
with
heading-hold/AVC
S setting in
idle-ups
1 and 2
and normal mode
setting in idle- up3
and normal.
Open and activate the GYRO
SENSE function.
for 1s to BASIC.(If ADVANCE
again) .
to GYRO-SENSE
Activate the function.
to MIX
，
to ACT.
Optional: Change gyro types to
Heading- hold (
GY
).
to MODE
，
to GY
Optional: Changes switch
assignment. Ex: select
Cond
.
to SW
，
to Cond
Adjust gyro rates as needed.
(Ex: NORM, IDL3 to NOR 50%.
IDL1 and 2 to AVC 50% as
starting points.)
to
NORM
,
，
to NOR 50%
to
IDL1
，
to AVC 50%
Repeat.
Close
