深圳市乐迪电子有限公司
59
3.2.5 CAMBER-FLP
CAMBER FLAP assigns the primary flap control [defaults to VR
(A)] to allow trimming in flight of the flap action. The up and down
travel of each flap (camber flaps: FLP1/2) can be adjusted
independently. Also the center position of flap servo can be
offset.
Note: If FLAP-TRIM is activated, you can not use CAMBER
FLAP function simultaneously.
Adjustability
• Rate: -100% to +100%, with a default of +30%
• Center position (CENTER): The operation reference point of flap can be offset. -100% to +100%, with a
default of 0%.
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display.
Goals
Steps
Inputs
Ex: Set the maximum
travel of 35% of the
total flap travel.
Open the CAMBER FLAP
function.
to BASIC .
again to ADVANCE
to CAMBER-FLP,
Adjust the up/down trim
amount separately.(Ex:
adjust to 35%)
to FLP
。
VR (A)
，
to 35%
，
VR (A)
，
to 35%
，
。
Or: adjust the center position
of flap servo
to CENTER
，
to desired point.
Close
Goals
Steps
Inputs
Set up a START to gain
maximum possible lift on
launch.
Each Aileron: 50%. Each Flap:
100%.
Elevator: -5% to compensate.
SWITCH (AT9=G, AT9=E.)
Note: switch is assignable.
(CONDITION)
KNOB(null)
Note: knob is assignable.
(CAMBER MIX)
Open OFFSET function
to BASIC .
again to ADVANCE
to OFFSET,
Switch to the START condition.
G or E from NORMA to START
Set the rates. (Ex: AIL 50%,
FLP 100%, ELEV -5 %.)
to AIL
，
to 50%,
Repeat for FLP and ELEV.
Close
