深圳市乐迪电子有限公司
60
3.2.6 Camber Mixing
This function adjusts the mixing rate of camber operation which
operates the wing camber (ailerons and flaps) in the negative
and positive directions. The aileron, flap, and elevator rates can
also be adjusted independently and attitude changes caused by
camber operation can be corrected.
Also the operation reference point of camber control can be
offset. (PRE)
Note: Camber control is not assigned at initial.
Adjustability:
• Rate: -100% to +100%, with a default of +30%
• Reference point (PRE): The operation reference point of camber control can be offset. -100% to +100%,
with a default of 0%.
3.2.7 AILE/ RUDD MIX
You can select a pre-programmed mix which is used to mix the
rudders with aileron operation or the ailerons with rudder operation.
Aileron-to-rudder mix (AILE RUDD): automatically creates a
"coordinated turn".
Rudder -to-aileron mix (RUDD AILE): used to counteract
undesirable roll (roll coupling) that happens with rudder input,
especially in knife-edge.
Adjustability:
• RATE range of -100 to +100. Negative setting would result in
opposite rudder (aileron) action from aileron (rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in
2 separate positions of the same SWITCH.
Goals
Steps
Inputs
Ex: set the mixing
amount for aileron
to 40%, camber
control to VR (E),
reference point to
desired point.
Open the CAMBER MIX
function.
to BASIC .
again to ADVANCE
to CAMBER-MIX,
Choose desired slider.
to VR
，
to VrA
Adjust the mixing amount for
AILE. (Ex: adjust to 40%)
to FLP
to VrA
，
to 40%,
Set the reference point.
to PRE
，
or
VrA to desired
point
for 1 sec.
Close
