深圳市乐迪电子有限公司
73
3.3.9 DELAY
The Delay function provides a smooth transition between the trim
positions whenever OFFSET, REVO, MIXING, or THROTTLE HOLD
functions are turned on and off.
Adjustability:
• Separate delay times are available for aileron, elevator, rudder,
throttle, and pitch.
• With a 50% delay setting, the servo takes about a half-second to
move to its new position, quite a long time.
• In general, delays of approximately 10-15% are sufficient.
Goals
Steps
Inputs
Set up a delay on all
channels to ease the
transition from one flight
condition to another so
there are no ‘hard
jumps’.
Open the DELAY function.
to BASIC menu,
again to ADVANCE
to DELAY
Adjust AILE response as
needed. (Ex: aileron to +8%.)
to RATE-AILE
，
to 8%,
Repeat for other channels.
to ELEV. Repeat steps above.
Close menus and confirm
slowedtransitions.
E(AT9) from NORMAL to IDL2.Check
that the servos move gradually to new
3.3.10 GOVERNORS
The Governor mixing function is used to adjust the Governor speed settings (rS1, rS2, rS3) from the
transmitter.
What is a governor? A governor is made up of a set of sensors which read the RPM of the helicopter’s head,
and a control unit that automatically adjusts the throttle setting to maintain a constant head speed regardless
Select IDL2.
to NO.
，
to IDL2,
Adjust trim settings as
needed. (Ex:rudder to +8%.)
to RUDD
，
to +8%
，
Close menus and confirm
slowed transitions.
E (AT9) from NORMAL to IDL2.Check the
changes of rudder trim.
