6
Note:
If the motor only beeps once when toggle the switch of channel 7 (CH7) to the unlock position, the unlocking fails. Please
follow the methods below to troubleshoot it.
1. Check whether the throttle is at the lowest position. If not, please push the throttle to the lowest position until the motor
emits a second long beep, which means the unlocking is successful.
2. Since the PWM value width of each transmitter may be different, when using other transmitters except RadioLink T8FB/T8S,
if the unlocking still fails even though the throttle is at the lowest position , you need to increase the throttle travel in the
transmitter. You can toggle the switch of channel 7 (CH7) to the motor unlocking position, and then adjust the throttle
travel from 100 to 101, 102, 103... until you hear the second long beep from the motor, which means the unlocking is
successful. During the process of adjusting the throttle travel, be sure to stabilize the fuselage to avoid injuries caused by
blade rotation.
Take RadioLink T8FB/T8S transmitters as examples:
Note: When using other brand transmitters, please refer to the following picture to locked/unlock the motor. The value range
of channel 7 (CH7) is as shown below: