7
Transmitter Setup
1. Do not set any mixing in the transmitter when Byme-DB is mounted on the aircraft. Because there is already the mixing in
Byme-DB. The mix control will automatically take effects according to the flight mode of the aircraft. If the mixing function
is set in the transmitter, there will be conflicts of mixing and affect the flight.
2. If RadioLink transmitter is used, set transmitter phase:
Channel 3 (CH3) - Throttle: Reversed
Other channels: Normal
Note: When using a non-RadioLink transmitter, there is no need to set the transmitter phase.
Power-on and Gyro Self-test
Each time the flight controller is powered on, the gyro of the flight controller will perform self-test. The gyro self-test can only
be complete when the aircraft is stationary. It is recommended to install the battery first, then power up the aircraft and keep
the aircraft in a stationary state. After the aircraft is powered on, the green indicator light on channel 3 will be always on. When
the gyro self-test passes, the control surfaces of the aircraft will shake slightly, and the green indicator lights of other channels
such as channel 1 or channel 2 will also turn solid.
Note:
1. Due to differences in aircraft, transmitters and other equipment, it is possible that the green indicators of other channels
(such as channel 1 and channel 2) will not be on after the gyro self-test of Byme-DB is complete. Please judge whether the
self-test is complete by checking whether the control surfaces of the aircraft shake slightly.
2. Push the throttle stick of the transmitter to the lowest position first, and then power on the aircraft. If the throttle stick is
pushed to the highest position and then power on the aircraft, the ESC will enter the calibration mode.
Attitude Calibration
Flight controller Byme-DB needs to calibrate the attitudes/level to ensure the balance status.
The aircraft can be placed flat on the ground when performing attitude calibration. It is advised to lift the model head with a
certain angle(20 degree is advised) for beginner to ensure smooth flight and attitude calibration will be recorded by flight
controller once the it is complete with success.
Push the left stick (left and down) and the right stick (right and down) as below and hold more than 3 seconds. The green LED
flashes once mean the calibration completed.
