RadioLink Electronic Ltd
www.radiolink.com
18
firmware, please follow the tutorial on the Firmware page of CB86-PLUS on RadioLink official website.)
Apple computer system is not supported.
3.
Color screen CB86-PLUS: Connect the charger to the computer via USB cable.
If the charger
screen flashes
, you can install firmware of Mac file. XP, win7-win10, and Apple computer systems are
all supported.
5.2 Upgrade steps
1
．
C
onnect
CB86-PLUS
to the computer with a
Micro
USB cable
2
．
Power on CB86-PLUS and the computer will recognize the disk.
3
．
Format the disk. (Note: The operation is only for the firmware. It won't format any other file in your
computer. )
4
．
Copy the new firmware to U disk
5
．
Unplug the USB cable and the firmware upgrade is complete.
Part 6. Voltage Calibration of CB86-PLUS
1. Use a multi-meter to measure the power supply voltage for the charger and record the measured
voltage. The power supply voltage must be within the range of 11V-15V.
1. Use a multi-meter to measure the normal battery voltage and record the measured voltage. The
measured voltage of the cell must be within the range of 3.8V-4.4V.
Note
: If the cells of the battery measured is more than 1 piece, such as 2S or 6S batteries, you must
measure the voltage of the first cell next to the black cable of the battery balance port, as shown in the
picture below. Connect the black cable of the multi-meter to the black cable of the battery, and
connect the red cable of the multi-meter to the cable next to the black cable of the battery.
