Radiolink Electronic Limited
www.radiolink.com
6
bottom position means that F110S will flight in Stabilize Mode.
3.3 Power on and Bind
3.3.1 Power On
(1) Orange propellers default indicate the head direction, if you change the propellers, you can
make sure the head direction by check the flight controller CS360(like the picture), make sure
before power F110S on.
(2) Please put the F110S on
a
level
surface, the green LED will blink after power on about 2
seconds, do not move F110S when green LED blinking.
(3) F110S finished the calibration after green LED off.
Attention:
Head direction have been determinate, if you put not same as the direction that when
you calibrate, it will back to the same direction automatically when F110S start to fly, that we called
Head Front Forward Point Without Compass.
3.3.2 Bind
F110S sells with receiver R6DSM or R8FM.
(1)
Place the transmitter and the receiver close to each other within 1 meters.
(2)
Turn on the transmitter, then power on the R6DSM or R8FM.
(3)
Connect R6DSM or R8FM to flight controller CS360(it defaults connect).
(4)
There is a black button on the R6DSM and R8FM, press the binding button twice in two seconds
and release, receiver light starts blinking, after about 8 times blinking, match code success when
receiver signal LED always on!
