RadioLink Electronic Limited
10
③
Enter ADVANCE MENU, select ATTITUDE and set the CHANNEL as CH5, SW3 as SWC with up
position as Alt-Hold Mode(Low Speed), middle position as Alt-Hold Mode(HIgh Speed) and low position as
Stabilize Mode.
* For more setting instructions of different RadioLink transmitters, please visit
corresponding detailed e-manual.
3.6 Binding
If it’s the RTF version( whole pack including T8S+F121+bag) purchased, there’s no need to bind because the
binding is complete with receiver R8SM installed
by factory default. However, if it’s only the aircraft F121 is
purchased, binding between the transmitter and F121 with receiver installed needs to done first.
If fly F121 with RadioLink transmitter and receiver, binding steps are same as following.
①
Place the transmitter and receiver(installed on F121) close to each other within 50 centimeters.
②
Power on the transmitter and F121.
③
There is a black binding button(ID SET) on the side of the receiver, press it for more than 1 second.
When the LED starts flashing, meaning binding process has started.
Alt-Hold M.
(Low Speed)
Alt-Hold M.
(High Speed)
Stabilize M.
Alt-Hold M.
(Low Speed)
Alt-Hold M.
(High Speed)
Stabilize M.
