RadioLink Electronic Ltd
7
ID first. When all the devices are turned on, you can control one of the devices through the Child ID
function. At this time, the other devices are on standby.
For example: Bind RC8X with a truck and a car and turn all them on. First, use RC8X to control the
car to run to the bucket of the truck, and then switch the receiver ID on the truck to drag the car back to
the destination.
Child ID mode setting steps:
1. Tap the button at the right of the "Child ID mode" to change it from "OFF" to "ON". Set the ID number
according to your cars or boats and then finish the bind and parameters set for each receiver.
2. Once finished the Child ID mode setting, the corresponding ID number will be displayed on the main
interface of RC8X. (For example: ID_1) Change the ID number by click "-" or "+", click Reset will make
the ID number back to ID_0.
4. Working Modes
R8FG has a built-in gyroscope, which can output not only PWM signals but also PPM and SBUS signals.
There are four working modes, including ordinary PWM mode, SBUS mode, Gyro mode, and Gyro +
SBUS mode. The channel signal corresponding to each mode is as follows:
R8FG Working Mode
Working Mode
PWM Mode
SBUS Mode
Gyro mode
Gyro+SBUS
Mode
Note
Channel
Telemetry
Telemetry Port of Model Battery Voltage
（
+ -
）
TELEMETRY port is only for 2S-8S battery voltage telemetry. The port
cannot be used to power the receiver.
1
PWM
PWM
PWM
PWM
Steering
2
PWM
PWM
PWM
PWM
Throttle
3
PWM
PWM
PWM
PWM
Aux
4
PWM
PWM
PWM
PWM
Aux
5
PWM
PWM
PWM
PWM
Aux
6
PWM
PWM
PWM
PWM
Aux
7/PPM
PWM
PPM
PWM
PPM
Aux
8/S.BUS
PWM
S.BUS
PWM
S.BUS
Aux
