RADIOLINK ELETRONIC LIMITED
www.radiolink.com
25
(6) When ending setting, return to the initial screen by pressing “Exit” button twice.
4.17 Channel 3 Position "AUX"
The channel 3 and channel 4 servo position can be set from the transmitter. When CH3 is assigned to
the 3
rd
channel key, this setting is linked to the key. When CH3 and CH4 is not assigned to the 3rd
channel key, it can be set with this screen.
You can also set the CH3, CH4, CH5 and CH6 as VR at the same time, or SW.
Channel 3 position (POSI)
SW(LOCK) or VR(RATE)
Channel 4 position (POSI)
SW(LOCK) or VR(RATE)
Channel 5 position (POSI)
SW(LOCK) or VR(RATE)
Channel 6 position (POSI)
SW(LOCK) or VR(RATE)
(1) Enter the function menu and use “Dec(-)” or “Inc(+)” button to access AUX function.
(2) Press “Enter” button to get into CH3, CH4, CH5 or CH6 function interface.
(3) Use “Dec(-)” or “Inc(+)” button to select Channel setup item.
Use “Dec(-)” or “Inc(+)” button to select POSI, press“Enter”key and the value will blink, use
“Dec(-)” or “Inc(+)” button to select “VR” or “SW”.
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
If you use RC6GS to control RC
crawler, you can setup each channels
as below.
CH1 is rudder,
CH2 is throttle,
CH3 can setup to control the
transfer case,
CH4 can setup to control the shift
gear,
CH5 can setup to control the
front locker and
CH6 can setup to control the rear.