PROGRAMMING THE T6EAP RADIO
Anytime you wish to view or change any of the current settings in the transmitter, the programming mode must first be
entered by, of course, turning on the power, then by pressing the
2“MODE”
keys simultaneously and holding them
down for one second. Once “in the program” the
MODE
key will be used to scroll through all of the functions (model
number/ data reset/ model name, reversing, dual rates/ exponentials, end point adjustments, trim, programmable mix,
“flaperon” mixing, “v-tail” mixing, “elevon” mixing, flap trim) and the SELECT key will be used to view the settings
within the function. When a data change is actually required the “
DATA INPUT
” button will be used to increase or
decrease the value of the item displayed, thus making the change.
You can return to the “
home
” screen (where the model number and battery voltage is displayed) by pressing the
2”MODE” keys
simultaneously and holding them down for one second.
Model Select / Data Reset / Model Name
MODL - Model select function
To select model memory:
1. Access the Model Select function in the programming mode (by pressing the 2 MODE
keys simultaneously and holding them down for one second). The number for the current,
active model will be blinking.
2. To activate a different model memory press the DATA INPUT lever until the desired
model number appears.
3. Now the model has been selected. All programming inputs from this point forward will
affect only the model number on the screen (until another model number is selected).
PPM
MODL
1
RCST Data reset function
All the data for any model memory can be reset to the original factory defaults. Often this function is done to get a “fresh
To reset data:
1. Access the Model Select function in the programming mode (by pressing the 2
MODE
keys simultaneously and holding them down for one second). Use the
DATA INPUT
lever to
select the model memory you wish to reset.
2. Once the desired model number is displayed on the screen, press the
SELECT
key. A
“
REST
” will appear on the screen.
PPM
REST
1
CLR
3. Push
DATA INPUT
upward or downward for about 2 seconds to clear and reset the memory. “
CLR
” blinks first, and
then it stops blinking with a sound. Now the model data is reset to the initial setting that is the default value set at the
factory.
The existing modulation setting is not reset. If the power switch is turned off while reset is underway, the data may not be reset.
CAUTION:
Resetting the current model memory will permanently erase ALL programming information for that model.
The data cannot be recovered. Do not reset the model unless certainly you want flushing-out that memory and start from
scratch.
When actually setting up a model you should have the model in front of you with the power on so you can actually see the
effects of your programming inputs and measure the control throws.
Model name function
Assign a name to the model memory. By giving each model a name that is immediately recognizable, you can quickly
select the correct model, and minimize the chance of flying wrong model memory that could lead crash.
PPM
MDL1
1. Access the Model Select function in the programming mode (by pressing the
2 MODE
keys simultaneously and holding them down for one second). Use the
DATA INPUT
lever
to select the model number you wish to change.
2. Once the desired model number is displayed on the screen, press the
SELECT
key. A
NAME will appear on the screen.
7
