Radiolink Electronic Ltd
10
The F/S function is used in certain competitions to ensure safety landing of the model prior to flying away and
dropping. Conversely, it can also be used make all servos neutral to maximize the flight time.
DELAY:
Adjusts the synchronous ratio between the servos position and the actual operation. The default
value is 100 by factory setting meaning no delay.
3.3.3 ADVANCED Menu
There are four parameters to setup: ”D/R” “ATTITUDE” “ELEVON” “V-TAIL”
D/R:
Sets the auxilary switch to control the max and min values of corresponding channel range. Turn on “MIX”
(mix control) first and choose an auxilary switch to flip and set the max/min range value to its correspoding
channel by toggling. In the example picture shown above: When flip SWA upward and toggle CH1 stick , it
means the max/min range of CH1 can be +100 and -100. If the UP value modified to 50, it means the max
range can only be +50/-50 when toggle CH1 up and down. ‘DOWN” means when flip SWA downward, the
max/min value of CH1 is +100/-100.
ATTITUDE:
Turn on “CH”first and select the preferred channel. The values behind each channel means
different control percentage output different control signals.
Pilots can set 6 different modes (NORMAL, ATTI, GPS, HOVER, F/S and AUX) by adjusting the related rates.
Every mode has different rates to get a unique signal. NORMAL mode preset 0%, ATTI 50%, GPS 100%,
HOVER 25%, F/S 75% and AUX 50%. 0% means a output signal 1ms, and 100% means 2ms.
Note
If flight controller used is RadioLink PIX or Mini Pix, no setup needed here by default.
ELEVON:
Turn on “MIX” (mix control) first, adjust the aileron distance and allow aileron differential.
ADJUSTABILITY:
•
CH1 and CH2 are required.
•
Independently adjustable aileron travel allows aileron differential.
•
Independently adjustable elevator travel allows for differences in up vs. down travel.
•
The separate ELEVON settings for each condition can be set. (GLIDER only)
