Radiolink Electronic Ltd
12
2. Control a certain axis with two or more servos(eg. 2 rudder servos);
3. Correct special movement automatically (eg. Lower FLAP and ELEVATOR servos at the same time);
4. Control the second channel to respond to the movement of the first channel(eg. Increase smoke oil to
respond to high speed, but only when the smoke switch is activated).;
5. Turn off the main control under certain circumstances (eg. For dual-engine aircraft, turn off a motor or speed
up/down one motor to assist rudder to turn)
PROG. MIX1: the mix control of AILERON and ELEVATOR servos is to assist turning.
PROG. MIX2: the mix control of ELEVATOR and FLAP servos is to loop in small diameter.
Adjustability: Channel 1 to 8 can be personalized to mix.
MAS: Master channel. Other channels need to cooperate with movements of the master channels.
SLA: Slave channel. Many mix controls are controlled by one master channel. Eg. Rudder-Aileron mix control
with ration of 25% to correct rolling. No switch is needed.
Chapter 4 T8S Parameters Setup via Computer
4.1 Software Installation and Connect
Connect the computer and the T8S with an android USB cable (No OTG cable needed)
Open the parameter setup software in the downloaded file
，
then power on T8S
Choose Port Number( COM port will be automatic identified when connected), setting baud rate:
115200
,
8-1-None
(8 data bits, 1 stop bit, no parity check), click OPEN to connect.
Note
When click OPEN to connect, the SETTING parts mentioned above will turn grey and can’t be changed
and PARAMETERS at bottom right will be displayed
