27
Extended trims
：
Fine-tuning extension, allowing fine-tuning to cover the entire
gimbal range, instead of ± 25%
Display trims
：
Modify the precision of the fine-tuning step. The accuracy can be
modified according to actual requirements.
Throttle
：
Throttle related settings
Reverse
：
Throttle reverse
Source
：
Throttle operation source (input source), because the throttle trigger
timer is used, such as the THs function, it is usually set to the throttle channel
instead of the gimbal, so that the throttle lever operation triggers the timer
correctly
Trim idle only
：
Throttle trim only affects the low position, where trim only
affects the idle part of the throttle stroke and does not touch the entire throttle
range.
Preflight Checks
：
Pre-flight check, when booting or loading the model, the
system will check the following default settings, if it does not match the
following model settings, the system will pop up a security warning page
Display checklist
：
Show checklist
Throttle state
：
Throttle status warning, when the radio control is powered on
or the model is loaded, if the throttle stick is not at the lowest position, a
warning will be issued
Switch positions
：
Switch position check, defines whether the radio-control
checks whether the switch is in a predetermined position when the radio control
is powered on or when loading a model. To set them, place all the switches in
the way you like, and then press and hold ENT (the confirmation key), the
system will save all current switch positions as default values
Pots & sliders
：
Check the position of the knob and slider. The default position
of the preset knob and slider is the same as above.
Center Beep
：
Center prompt sound, select whether the gimbal, knob and slider
will emit a prompt sound when reaching the center point.
Use global funcs
：
Use global function settings, choose whether to apply global
function settings to the current model
