30
"Global" means that global variables can be used to set pages for the entire model,
but not for all models. Each model has its own set of global variables.
There are 9 global variables available. 0 being the default value.
Modify the value directly or press and hold the ENT key to pop up the sub-menu
to change the type and parameter of the global variable.
Name
: Setting name
Unit
: Units, switchable between normal and%
Precision
: Precision, which can be used in decimal mode. You can set this mode
corresponding to the percentage.
Min
: Minimum value, which can be limited when the value is changed
dynamically
Max
: Maximum value, which can be limited when using dynamic change values
FM0-FM8
: You can specify a value for each flight mode or set it to be the same
as the other flight modes. Press and hold the ENT key to switch the input value
and select the flight mode in this field. When editing a value, it will increment /
decrement by 1 or 0.1, depending on the "Precision" setting above.
4.4.4. Input Source（Inputs）
The Inputs page defines the input source. Before outputting to the channel, you
can make preliminary settings for the input source, such as limiting the amount of
operation, increasing the curve, using the switch pair to switch, etc.
The input source can be a physical operation source such as a gimbal, knob, or
switch of the radio control, or it can be a global variable Gvar, a logical switch,
telemetry data, etc.
