D9133TTL-E Serial Interface Module Installation Instructions
© 1999 Radionics
Page 1
41124B 3/99
D9133TTL-E Ethernet Interface Module
Installation Instructions
Description
The D9133TTL-E is an SDI bus device for use with the 9000/7000 Series Control/Communicators (D9412, D9112,
D7412, D7212). The D9133TTL-E is used for bi-directional communications over Ethernet networks which are typically
used for event reporting and remote programming.
LED Enable Jumper (P2)
SDI Bus Connection
Terminal Strip
Ethernet Interface
Indicator LEDs
Address Jumpers
1 2 4 8
LEDs
Ethernet Link LED
Figure 1: D9133TTL-E Circuit Board Layout
Specifications
• Dimensions:
7 inches x 4.5 inches (17.8 cm x 11.4 cm)
• Current Draw:
500 mA
• Compatibility:
D9412, D9112, D7412, D7212 Control/Communicators with firmware version 05.22 and higher
• Connectors:
Control Panel:
SDI Bus Terminal Strip
LAN/WAN:
'RJ' Modular Jack (Ethernet)
Installation
1. Remove AC and battery power from the Control/
Communicator.
2. Wire the D9133TTL-E to the Control/Communicator as
indicated in Figure 2 and in the table below.
Control/Communicator
D9133TTL-E
SDI PWR (Terminal 32)
SDI A (Terminal 31)
SDI B (Terminal 30)
SDI COM (Terminal 29)
SDI PWR
SDI A
SDI B
SDI COM
NOTE: SDI device wiring is limited to 1,000 feet (304.8 meters).
3. Connect an Ethernet cable to the Modular Jack labeled Ethernet.
4. Set up the D9133TTL-E as described on page 2.
5. Reconnect AC and battery power to the Control/Communicator and power up the system.
D9133TTL-E
PERIPHERAL DEVICE WIRING
RED
YELLOW
GREEN
BLACK
POWER +
DATA BUS A
COMMON
DATA BUS B
31
30
32
29
Control/Communicator
Figure 2: Wiring the D9133TTL-E
