© Copyright 2023. Radisys Corporation, All Rights Reserved.
7
Radisys ES4001G ONT Quick Installation Guide
6
3.2 Mounting ONT on a wall
ONT has two mounting holes that can be used for wall mount placement.
Please see diagram for screw separation and location.
ONT should be mounted with LEDs facing up and service interfaces facing
down to avoid dust and contamination.
4
Web Graphical User Interface
You can access the ONT through a web browser using the following steps:
- Connect an Ethernet cable from your computer the LAN port.
- Launch a web browser or telnet session and connect to address
192.168.1.1.
- After response, enter the following:
1. Username: admin
2. Password: Serial Number of the respective device in
UPPER CASE (printed on back side of the device)
5
Troubleshooting
The Power LED on the front panel is off after pressing the Power switch.
-
Verify that the power adapter is connected correctly to the device.
-
Be sure to use the supplied power adapter with the device. The PON
LED on the front panel is off or green flashing after the device is
powered on.
-
The PON link is not established.
-
The ONT is not registered.
-
Contact the service provider for help.
-
The LAN LED on the front panel is off after the device is powered on.
-
The corresponding LAN is not established.
-
The Ethernet cable is not connected correctly.
-
The network device connected to the LAN is not powered on.
-
The LOS LED on the front panel is flashing red after the device is
powered on.
-
The optical fiber cable is broken or damaged.
-
The optical fiber cable is not connected to ONT PON device correctly.
-
Please contact the service provider if the LED is flashing red.
