6 Steps to Operation
8
EPC-2322 SBC (P3000(D)BX2 Series)
Service Manual
Handling the P3000(D)BX2
Overview
This section suggests basic precautions when handling the P3000(D)BX2 series SBC.
Static
Electricity
The P3000(D)BX2 is designed with protection against ESD (electro-static discharge)
and excessive voltage. However, excessive static electricity can damage components.
Before you handle the SBC, use the grounding wrist strap provided with the system to
discharge the static electricity from your body. Instructions for using the wrist strap are
printed on the strap's envelope.
Safety
It is important to protect yourself and your equipment before you perform any of the
procedures outlined in this manual.
You should check the configuration before you install the SBC. If the SBC is already
installed in your system and you need to change the configuration, power-off the
system and disconnect all power cords from their source. Follow all safety precautions
as outlined by the chassis manufacturer.
Next...
Before you install the SBC in a chassis, check the following:
•
Jumper settings, outlined in Step 1,
•
DIP switch settings, outlined in Step 2,
Pay particular attention to the switch settings. The jumper settings are pre-configured at
the factory and are appropriate for most applications.
Handle the SBC by the edges to help prevent accidental damage caused by
static discharge (
To avoid damage or injury, always power-off the system and disconnect all power cords
from their source before handling the equipment.
To help prevent accidental damage caused by static discharge, use a grounding wrist
strap or other static-dissipating device when handling the equipment.
Um Sachschaden und Verletzung zu vermeiden, schalten Sie vor Arbeiten am Gerät
den Netzschalter aus, und ziehen Sie alle Stecker aus den Steckdosen.
Um unbeabsichtigte Schäden durch elektrostatische Entladung vorzubeugen, sollte bei
Arbeiten am System immer ein Erdungsarmband getragen oder andere
elektrostatische Entladungs-Vorsichtsmaßnahmen verwendet werden.
Only qualified, experienced electronics service personnel should access and handle
the equipment.
Es sollte nur qualifiziertes und erfahrenes Fachpersonal am System arbeiten.
StockCheck.com
Summary of Contents for P3000BX2 Series
Page 14: ...Introduction 6 EPC 2322 SBC P3000 D BX2 Series Service Manual Notes S t o c k C h e c k c o m...
Page 62: ...Technical Data 54 EPC 2322 P3000 D BX2 Series Service Manual Notes S t o c k C h e c k c o m...
Page 64: ...Technical Data 56 EPC 2322 P3000 D BX2 Series Service Manual Notes S t o c k C h e c k c o m...
